← D-18 Serial Lookup

Nut String Spacing

How Bryan lays out a nut at the bench — plus a model to check one you already have, or lay one out three ways.

Center-to-center = gap + ½(string A) + ½(string B). The gap is the open space between two strings; the center distance is string centerline-to-string centerline.

How Bryan Cuts a Nut

In his own words, from the bench:

  1. Lock your calipers at the desired gap — 0.257″ for a 1-11/16″ nut, 0.264″ for a 1-3/4″ — and use the jaws as a spacer. (A 7/16″ nut ≈ 0.260″ wide works as a spacer too, but the calipers are already in hand.)
  2. Make the nut longer than needed. Lay the low E, cut its slot a little, place the string.
  3. Put the calipers in, space the A, mark, cut. Check each string before moving to the next. Repeat across the nut, every pair spaced 0.257–0.260″.
  4. Scoot the long nut over until the E's sit where you want them on the board. You'll land around 0.100″ from the edge of the E to the edge of the board — but that margin is a side effect. The spacing matters far more.
  5. Then mark and trim the nut to length.

String Gauges

Enter the set you're using (inches). These feed all three modes below.

Mode

center = gap + ½·gaugeA + ½·gaugeB  |  gap = center − ½·gaugeA − ½·gaugeB. A reference tool from Bryan's bench — measurements are a starting point; trust your calipers and your eye.

A tool from Bryan's Bench · The D-18 Listening Project